Advertisement
Available languages
Available languages
5.
Completing the Inslsllatlon for All Models
•
Carefully slide the air conditioner back into
the cabinet, (in window)
(please seek assistance for this procedure)
Reinstall (slide-out-chassis) secudly screws
removed earlier on the (lower left]right) side of
Ihe cabinet, Fig. 7
•
Expand Ihe shutter frames (fully) on each side
and secure the top of the frames to Ihe window
sash using one 314" screw & flat washer on
each side. Fig. 23
•
Install shutter clamp on each s]de of the Oower)
shutler and secure to window sill using one
3/4" screw & flat washer on each side. Figo23
58,
e
e
o
Reinstalling
Front Panel Grill:
Position the front panel assembly on the
cabinet starting at the top. The front panel lock
labs must be inserted inlo the retaining slots in
the cabinet.
Repeat this procedure on al[ sides, making sure
the fresh air ventilation lever arm and power
cord are properly installed back to their original
positlon_
Secure the front gdfl to the cabinet using the
phillips screws removed eartier_ Flg'xo 1 & 2
install the air filtar_
Cut the second foam seal Is fit the opening
between the lop of the inside and outside
window.
(Fig..24,)
Some Installations may require additional
sealing around the window and air conditioner..
Check for any air teaks and seal where
necessary.
LJndervery humid conditions, water removai
may be excessive enough to overflow from Ihe
rear of the unit or increase noise levels of the
air conditioner° If this occurs, consider attaching
a standard drain (garden) hose (not
included) to the drain plug at the rear of the
unit, allowing condensation
to run off
conveniently (Fig° 254)
che_l_
Fig,7
Clamp
Fig. 23
2nd Fo_n
Seal
Fig, 24
,
iii
Drain Hose
(nbt Included)
Fig. 25
Advertisement
