KVH Industries Vision C3 Owner's Manual page 21

14. At each hole, place a
1 ⁄ " -20 x 3" bolt (from the kitpack) and insert it into
4
the mounting hole from above (see Figure 2-9).
Flat Washer
Silicone
Mounting Plate
Silicone
Deck
Flat Washer
Lock Washer
Hex Nut
15. Apply a flat washer, lock washer, and nut
(removed in Step
below decks and tighten securely.
16. When the antenna unit is installed with the
baseplate connectors facing the stern of the vessel,
the drain holes are located as shown in
Figure 2-10.
Factory-drilled
Drain Hole Positions
54-0159 Rev. G
1
⁄ " flat washer on a
4
Bolt
TracVision
Baseplate
7) to each mounting bolt from
Figure 2-9
Securing TracVision C3
to the Deck
Figure 2-10
Baseplate Connectors Facing Rear
of Vessel – Factory-drilled
Drain Hole Locations
Bow
Installation
2-7