Table of Contents
Advertisement
7. Wire cable assembly as shown in the figure below.
To J8 of
ANLG Board
8. Mount the ANLG board on the heat sink referring to step 2. Fasten cable assy.
S.FL2-2LP0.7-D-WHT (250), 8P connector cable and 6P connector cable by
cable tie (CV-100, supplied) as shown in the figure below. Fix cable assy. S.FL2-
2LP0.7-D-WHT (250) with vinyl tape.
MAIN Board
ANLG Board
J8
9. Connect J1 of GR-7000A to J8 of ANLG board (Refer to Figure 4-6).
10.Mount chassis assembly on the panel assembly. Connect 8P connector and 6P
connector to Main board as shown in Figure 4-8.
Reattach this tape as
shown right after the
DGPS connection.
GN-7707
GR-7000A
J1
J2
J3
Figure 4-6 Wiring the Cable assembly
6P connector
10 mm
40 to 45 mm
vinyl tape
GN-7707
Figure 4-7 Attaching cable tie
4-5
J2
Connector
PH6P-W-L240
8P connector
40 to 45 mm
10 mm
Cable
tie
Advertisement
Table of Contents
