Table of Contents
Advertisement
DGPS port
1. Press the [MENU] key.
2. Press the software key labeled "CONFIGURATION".
3. Press the software key labeled "SETUP NMEA/DGPS PORT 2".
4. Select "FORMAT" by the arrow key.
5. Press the software key labeled "EDIT" to display the following message.
s FORMAT
DGPS 3D
Figure 3-2 Output Format Display, DGPS port
6. Select NMEA version, external DGPS or internal DGPS by the arrow key.
NMEA0183 Ver1.5/Ver2.0
RTCM104(EXTRN)
RTCM104(INTRN)
RTCM104(OUTPUT)
Note 1) You cannot setup sentences when you select RTCM104 as the format.
Note 2) For RS-422 format, the level converter (IF-1432) is required for connection
of external equipment.
7. Press the software key labeled "ENTER".
8. Press the [PLOT] key to finish.
OUTPUT FORMAT
NMEA 0183
VER 1.5
NMEA0183 Ver1.5
' NMEA0183 Ver2.0
RTCM104 (EXTRN)
RTCM104 (INTRN)
RTCM104 (OUTPUT)
: Select one when connecting PC or RS-232C
equipment.
: Select this when connecting external DGPS
beacon receiver.
: Select this for builtin internal DGPS beacon
receiver.
: Selecct this when outputting differential data of
the internal DGPS beacon receiver to other GPS
navigator.
3-2
SETUP
PORT2
ENTER
CANCEL
Advertisement
Table of Contents
