Using C-Map Nt Model; Inserting Chart Card; Cussor And Data Display - Furuno GP-1850F Operator's Manual

The GP-1850DF/1850F C-MAP NT series
uses FURUNO mini chart card and C-MAP
NT-FP chart card. These charts show
accurate coastlines, depth contours, place
names, aids to navigation such as buoys and
lighthouses, and other navigational marks.

12.1 Inserting Chart Card

Insert an appropriate chart card before
turning on the power.
1. Push down the lid catch to open the chart
card slot cover.
Figure 12-1 Location of chart card slot cover
2. Insert appropriate chart card groove side
up.
3. Close the slot cover to protect the chart
drive. (Keep the slot cover closed at all
times.)
Note1: Turn off the power before inserting or
ejecting the chart card.
Note2: When using C-MAP NT-FP card, do
not eject it while a chart is being drawn. This
may cause the equipment to stop working.

12. USING C-MAP NT MODEL

Card slot
12.2 Cursor and Data
Display
Besides its fundamental functions of
providing position data, the cursor can also
show caution area, depth area, source of
data, etc. Further, you can display information
about an icon by placing the cursor on it.
1. Press the cursor pad to turn the cursor
on.
34 12.345' N
135 12.345' E
DGPS 3D
Figure 12-2 Plotter display
2. Use the cursor pad to place the cursor on
the position desired.
3. Press the [ENTER] key to open the
Objects window. For example the
following window appears.
Objects
Caution area
Depth area
Source of data
Figure 12-3 Objects window
NORTH
FROM 16.45nm
OS 276.9
ZOOM
ZOOM
OUT
COURSE
GO TO
CURSOR
CENTER
12-1
UP
IN
UP