Kenmore 106.5114 Series Use & Care Manual page 19

Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can resuR in cuts.
Is the ice dispenser stalling while dispensing "crushed" ice?
Change the ice button from "crushed" to "cubed." If cubed
ice dispenses correctly, depress the button for "crushed" ice
and begin dispensing again.
Has the dispenser lever been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser will not operate properly
Check the following:
• Is the freezer door closed completely?
• Is the water shutoff valve not turned on, incorrectly installed
or clogged?
• Is the water line connected at the source?
• Is there a kink in the home water source line?
• Has the water system not filled? The water system needs to
be filled the first time it is used.
Is the refrigerator connected to a cold water line with water
pressure of at least 30 psi (207 kPa)? The water pressure to
the home determines the flow from the dispenser.
Is there a water filter installed on the refrigerator? The filter
may be clogged or incorrectly installed.
Is a reverse osmosis water filtration system connected to
your cold water supply? See "Water Supply Requirements"
in the Installation Instructions.
ACCESSORIES
Replacement Parts:
To order stainless steel cleaner or replacement filters, call
1-800-4-MY-HOME ® and ask for the appropriate part number
listed below or contact your authorized Kenmore dealer.
Stainless Steel Cleaner and Polish:
Order Part #D22 M40083 R
Water Filter:
Order Part #9930 (P4RFWB)
Air Filter:
Order Part #W10335147A
Produce Preserver:
Order Part #W10335145A
WATER FILTER
CERTIFICATIONS
State of California
Deparlment of Public ttealth
Water Treatment Device
Certificate Number
I0- 2030
Date Issued: FebruaI3, 26, 2010
Trademark/Model Designation Replitcemenl Elements
P5WB2 P4RFWB
Manufacturer: Whir poo C'orporat on
Water is leaking from the dispenser
Check the following:
• Is the glass not being held under the dispenser long enough?
• Has the water system been flushed since installation or
changing filters?
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
• Has the refrigerator been newly installed or a large amount
of water recently dispensed? Allow 24 hours for the
refrigerator to cool completely.
Has water not been recently dispensed? The first glass of
water may not be cool. Discard the first glass of water.
Ratf, d Sorviee Capacity: 2{)0 gal RatedService FIo_: 5 gpm
Conditions of Cerfilleation:
Do not use where water is microbiologically unsafe or with water of unknown quality, except _hat systems certified
lbr cyst mductlot_ may be used on disird;actcd waters that may comain filterable cysis,
19