Advertisement
LP Tank Exchange
• Many retailers
that sell grills offer you the op-
tion of replacing
your empty LP tank through
an
exchange
service.
Use only
those
reputable
exchange
companies
that
inspect,
precision
fill, test and certify
their cylinders.
Exchange
your tank only for an OPD safety feature-equipped
tank as described
in the
LP Tank section
of
this manual.
• Always
keep new and exchanged
LP tanks in
upright
position
during use, transit
or storage.
• Leak test new and exchange
LP tanks BEFORE
connecting
to grill.
LP Tank Leak Test
For your safety
• Leak test must be repeated each time LP tank is
exchanged
of refilled.
• Do not smoke during leak test.
Basic Lighting Procedures
1.
Familiarize yourself with the safety guidelines at
the front of this manual. Do not smoke while
lighting grill or checking gas supply connections.
2.
Be sure the LP gas tank is filled or the Natural
Gas Line is attached to the gas source.
3.
Check that the end of each Burner Tube is properly
located over each Valve Orifice.
4.
5.
Make sure all gas connections are securely
tightened.
Open the Grill Lid or Side Burner during lighting,
depending on the burner you are lighting.
Z WARNING
Failure
to open Grill Lid during the
lighting
procedures
could result in a fire
or explosion
that could cause serious
bodily
injury, death,
or property
damage.
• Do not use an open flame to check for gas leaks.
• Grill must be leak tested outdoors in a well-ven-
tilated area, away from ignition
sources such as
gas fired or electrical
appliances. During leak test,
keep
grill away from
open flames
or sparks.
.
Set Control Knobs to OFF and open the LP gas
tank valve slowly until 1/4 to 1/2 open.
Open LP
IN
gas tank
OFF
_--'-_
• Use a clean paintbrush
and a 50/50
mild soap
and water solution.
Brush soapy solution
onto
areas
indicated
by arrows
in figure
below.
WARNING
If growing bubbles appear do not use or move
the LP tank. Contact an LP gas Supplier or your
fire department!
• Do not use household
cleaning
agents. Damage
to gas assembly
components
can result.
l\
7. Push and turn the LEFT Control Knob to HIGH.
|
HIGH
OFF I
i
8.
Immediately
press the Electric
Ignitor for 3-4
seconds to light the Burner.
PRESS
J
g.
10.
If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes, and repeat the
lighting procedure.
Once the left grill burner is ignited, the adjacent
burner can be lit by simply turning its Control Knob
toHIGH.
11. Adjust Control Knobs to your desired cooking
temperature.
24
Advertisement
