Advertisement
_'_
Installing
Side Burner
Kit
1. Insert the Side Burn--s
Valve Assembly through the Side Burner Gas Valve Hole on the Side
Burner Frame, See _
Align the 2 holes on the Side Burner Frame with the threaded
holes
on the Side Burner Gas Valve
Bracket. Tighten securely
using 2 screws and washers provided.
2.
Cut Fastening Band from Pot Support and set Pot Support aside. Install the Side Burner through
the top hole in Side Burner Frame and onto the Side Burner Gas Valve. Make sure that opening
at end of Side Burner Connection Tube goes over tip of Side Burner Gas Valve. Secure Side Burner
with supplied
Cotter Pin. See
,
4.
Push the Control Knob onto the Side Burner Gas Valve Stem. Be sure that the OFF position faces
the Burner. See
Connect the Electric Wire terminal from Side Burner with the other from Grill Head. See W
Thread the supplied Fastening Band through the hole on the top of the Right Cart Side Panel and
bind the connected Electric Wire and Regulator Hose together using the Fastening Band.
5. The gap,,between the Side Burner Electrode Tip and the Side Burner Port should be approximately
1/8-3/16.
See _
If the gap is wider than 3/16", use a pair of long nose pliers and gently
bend the Electrode Tip toward the burner.
6. Place the Side Burner Pot Support into the Side Burner Frame. See
7. Place the Side Burner Wind Shield on the Side Burner Frame. See
ilill
Pattern
Head Screw
M4x8mm
Qty. 2
Ref. # $132M04082
Plain Washer
M4
Qty. 2
Ref. # $411M04122
\
Control
Knob
Qty. 1
Ref. # P03426061C
li iil
Cotter Pin
Qty. 1
Ref. # P05501010B
Fastening
Band
Qty.
1
Ref. # P055340011
\
f
_ll_ll_
1/8"-3/16"
BURNER
SiDE
• When
you have finished
assembling
your grill we
strongly urge that all Pat-
tern Head Thumb Screws
be tightened,
either with
the
supplied
Tightening
Tool or a #2 Phillips Head
Screwdriver
WARNING
Be sure the Electric
Wire and Regulator
Hose are bound together
and fixed to the
hole on the top of Right Cart Side Panel.
2O
Advertisement
