Advertisement
_!
NG
Model
Only
Connecting
Natural Gas To Your Grill
For Natural Gas grills: Connect the grill end of
the 12' Natural Gas Hose to the horizontal
fitting
as shown.
Connect the hose end to the gas
supply line. Also, read the natural gas safety
instructions
on page 4.
SiDE
BURNER
GAS VALVE ASSEMBLY
BRASS
ADAPTOR
S_DE BURNER
CONNECTION
TUBE
HOSE,
12 ft./NG
Congratulations
Your Kenmore gas grill is now ready for use.
Before the first use and at the beginning
of
each season (and whenever
the LP gas tank
has been changed):
1. Read all safety, lighting and operating
instructions.
2. Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3. Perform gas leak check according
to
instructions
found on page 23 & 24 of
this manual.
Z WARNING
If you smell gas:
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Extinguish any open flame such as candle,
cigarette, lighter, etc., that could cause gas
to ignite.
• Open the Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues
or you have a fire you
cannot extinguish,
call your fire depart-
ment.
Do not call near the LP gas tank
because your telephone
is an electrical
device and could create a spark resulting
in fire and/or explosion.
NOTE: The normal flow of gas through the
regulator
and hose assembly
can create a
humming
noise. A low volume of noise is
perfectly normal and will not interfere with
operation
of the grill. If humming noise is
loud and excessive
you may need to purge
air from the gas line or reset the regulator
excess gas flow device. This purging proce-
dure should be done every time a new LP
gas tank is connected
to your grill. For help
call the Grill information
Center.
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1.
2.
Make a soap solution by mixing one part
liquid detergent and one part water.
Turn the grill Control Knobs to the full OFF
position,
then turn the gas ON at source.
.
4.
Apply the soap solution to all gas connec-
tions. If bubbles appear in the soap solution
the connections
are not properly sealed.
Check each fitting and tighten or repair as
necessary.
If you have a gas leak that cannot be re-
paired by tightening,
turn off the gas at the
source, disconnect
fuel line from your grill and
call 1-8OO-4-MY-HOME _ or your gas supplier
for repair assistance.
23
Advertisement
