Displayed Messages - Fisher & Paykel EB60DSXB Installation Instructions And User Manual

Displayed messages

30
EN
Displayed message
FILL TANK
GROUND TOO FINE
ADJUST MILL AND
(alternating with)
PRESS OK
GROUND TOO FINE
ADJUST MILL AND
(alternating with)
PRESS OK
(then) FILL TANK
EMPTY WASTE COFFEE
CONTAINER
INSERT WASTE COFFEE
CONTAINER
ADD PRE-GROUND
COFFEE
Possible causes
The water tank is empty or
positioned incorrectly.
The grinding is too fine and
the coffee is delivered too
slowly.
The machine cannot make
coffee as there is air in the
hydraulic circuit. Possible
cause: the filter has not been
installed correctly.
The tank has been removed
during delivery.
The waste coffee container ( A4) is
too full or more than 3 days have
passed since you last made coffee
(this guarantees correct hygiene
of the machine).
After cleaning, the waste coffee
container has not been replaced.
The "pre-ground coffee"
function has been selected
without placing any pre-
ground coffee in the funnel.
The funnel (A21) is blocked.
What to do
Fill the tank with water and/or
insert it correctly, pushing it as
far as it will go.
Turn the grinding
adjustment knob one click
clockwise towards "7".
Make sure the filter (A26) is
propertly installed and that
the installation has been
carried out correctly.
Insert the tank and press
the OK icon (B9). "HOT
WATER PRESS OK" is displayed.
Empty the waste coffee
container and clean, then
replace.
Important!
When removing the drip tray,
the waste coffee container
MUST be emptied, even if
it is not completely full. If this is
not done, when you make the
next coffees, the waste coffee
container may fill up more
than expected and clog the
machine.
Open the service door and
insert the waste coffee
container.
Extract the appliance and
place pre-ground coffee in
the funnel.
Empty the funnel with the
help of a knife as described
in the section "Cleaning the
pre-ground coffee funnel".