Related Manuals for Furman PS-PRO HT
Summary of Contents for Furman PS-PRO HT
- Page 1 P S - P R O H T - P O W E R C O N D I T I O N E R / S E Q U E N C E R MODEL: PS-PRO HT Home Theater Pro Level AC Power...
- Page 2 Three year limited warranty. I N T R O D U C T I O N Congratulations on your pur- chase of a Furman PS-PRO HT Power Conditioner/Sequencer. The PS-PRO HT offers maximum protection from AC line hazards faced by delicate ana- log and digital A/V equipment.
- Page 3 The PS-PRO HT is controlled by a front panel key-operated switch to provide security from non-authorized users tampering with the system. The switch has three positions: OFF, REM, and ON, allowing for local or remote control.
- Page 4 Furman’s Reference AC Line Voltage Regulators in addition to the PS-PRO HT. If you do use a voltage regula- tor, run the raw power line into the regulator first so that the PS-PRO HT receives a stabilized voltage to distribute.
- Page 5 For integrating the PS-PRO HT into computer control/touch screen systems use “momentary mode.” The PS-PRO HT main circuit board has 5 pairs of terminals labeled as: JMP1 (MAINT ON), when the REM and +12V terminals are tied together, the PS-PRO will sequence OFF.
-
Page 6: Front Panel
140V) and shuts the power down before damage can occur. Upon initially applying power to the PS-PRO HT, this indicator will be lit if the unit is receiving below 80 volts or more than 140 volts, and power will not be applied to the PS-PRO HT’s outlets. -
Page 7: Rear Panel
Adjust control on the front panel. TERMINAL STRIP: Allows one or more switches to be connected to turn the PS-PRO HT on and off from a remote location. Two, and sometimes three, wires are needed to install a remote switch (see “Main- tained Mode”, page 6.) If a four-conductor cable is... -
Page 8: Momentary Mode
OFF sequence. Momentary Mode In Momentary Mode (jumper plug installed on JMP2) the PS-PRO HT has “memory” — it only needs a momentary signal from the remote switch to change its state from ON to OFF. When first plugged in (or after power is lost and reapplied for any reason) the stored state is OFF. - Page 9 If it is turned back to REM, the PS-PRO HT will sequence back to ON because the stored state is still ON.
- Page 10 Furman factory or Authorized Repair Stations. This warranty shall be cancelable by Furman at its sole discretion if the PS-PRO HT unit has been subjected to physical abuse or has been modified in any way without written authoriza- tion from Furman.
- Page 11 P S - P R O H T - P O W E R C O N D I T I O N E R / S E Q U E N C E R PS-PRO HT SPECIFICATIONS Current rating: Input Voltage: Mains Wiring analyzer: Detects one normal mode and five fault modes...
- Page 12 P S - P R O H T - P O W E R C O N D I T I O N E R / S E Q U E N C E R Furman Sound, Inc. 1997 South McDowell Blvd.