Using #70 Relay Menu Mode; General Information - Honeywell Ademco VISTA-32FB User Manual

Using #70 Relay Menu Mode

General Information

Your system may be set up so that certain lights or other devices can be
turned on or off by using the #70 command from either a keypad or a
telephone keypad (if 4285 or 4286 VIP module is used). Ask your installer if
this has been done in your system.
To activate relays from a keypad, enter 4-digit security code + [#] +70.
Follow the keypad prompts described below.
To activate relays using a telephone and 4285 or 4286 VIP module,
first dial the 2-digit phone access code. When the system acknowledges the
access, enter 4-digit security code + [#] + 70. The following prompts/voice
responses will begin.
ENTER DEVICE NO.
00=QUIT
NN DEVICE IS OFF
HIT 0=OFF , 1=ON
NN DEVICE IS OFF
HIT THE "✴" KEY
– 42 –
Voice: "ENTER DEVICE CODE NOW"
01
Enter the 2-digit number of the device to be activated.
Note that if an invalid number is entered, the system
will simply ask you to reenter the number.
Voice: "voice descriptor DEVICE nn ON/OFF. FOR
voice descriptor ON ENTER 1, FOR voice descriptor
OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and voice
descriptor is the relay voice descriptor programmed
by the installer.
Voice: "voice descriptor DEVICE nn ON/OFF. TO
EXIT ENTER 00 NOW"
From a keypad, press ✴ to continue. The ENTER
DEVICE NO. prompt will appear.
From a telephone keypad, enter 00 to exit, or
enter the next relay number to be programmed. The
current on/off state of that relay will be annunciated
as described above. Alternatively, if 6 seconds elapses
with no key depression, the 4285 or 4286 VIP module
will annunciate the "ENTER DEVICE CODE NOW"
message.