INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4. Serial Interface Board: B-SA704-RS-QM-R
The pictures used in this section are those of the B-SA4TM, and the installation procedures are common
with the B-SA4TP unless otherwise noted.
•
Packing List
The following parts are supplied with the kit. Make sure you have all items shown below.
SIO PC Board (1 pc.)
Serial Interface Cable
SMW-3x6 Screw (3 pcs.)
NOTE:
Make sure that the Serial Interface Cable is connected to CN4 on the SIO PC Board.
•
Installation Procedure
1. Remove the two screws from the back of the printer.
SMW-3x6
Locking Support (1 pc.)
Installation Manual (1 copy)
4- 1
4. Serial Interface Board: B-SA704-RS-QM-R
PCB Support Plate (1 pc.)
Side Panel
EO15-33001A