Switching Off The Lights - Renault Latitude Handbook

EXTERIOR LIghTINg ANd sIgNALs
2 3
directional headlights
(depending on the vehicle)
With the dipped beam headlights on
and under certain conditions (speed,
steering wheel angle, forwards gear
selected, etc.) during cornering, the
dipped beam headlights move to light
the inside of the bend.
The directional headlights only operate
when the dipped beam headlights or
main beam headlights are lit.
Operating faults
If the headlight tell-tale flashes on the
instrument panel accompanied by the
message "Check lighting" (
warning light lit), it means there is a
lighting fault. Consult an approved
Dealer.
1.68
(2/3)
special note:
– If the dipped beam headlights are
manually switched on and if the light
1
is sufficient, the directional head-
lights will remain fixed;
– If the lights come on automatically
when cornering, the directional
headlights will start working from the
next time the vehicle corners;

switching off the lights

There are two possibilities:
– Manually
Turn ring 2 until symbol 0 is opposite
mark 3.
– Automatically
The lights go out when the engine
is stopped and the driver's door
opened. In this case, the next time
the engine is started the lights will be
switched back on according to the
position of ring 2.
©
"follow-me-home lighting"
function
This function is used to switch on the
dipped beam headlights temporarily
(useful in a dark car park, for example).
With the engine and lights switched
off, pull stalk 1 towards you. The dipped
beam headlights come on for approxi-
mately thirty seconds.
To extend this period, you can pull the
stalk up to four times within 10 sec-
onds of the first action. The total time
is limited to two minutes. The mes-
sage "See-me-home _ _ _" along with
the times the lights will be on for is dis-
played on the instrument panel to con-
firm this action.
To switch off the lights before they go
out automatically, turn ring 2 to any po-
sition, then return it to its initial position.