Renault Latitude Handbook page 25

dRIVER's sEAT WITh mAssAgE fUNcTION
6
4
3
Adjusting the lumbar support
on the driver's seat
You can increase or reduce the sup-
port by pressing the (+) or (-) button
on switch 3/4/5 for the top, middle and
bottom of the lumbar support respec-
tively.
– Take care not to damage the
seatback with sharp objects. The
air tubes incorporated in the seat-
back may also be damaged.
– In the event of prolonged use of
the massage function, you may
start to feel uncomfortable.
driver's seat with massage
function
When the engine is running, you may
use the massage function. If you start
the system, the air pressure drops com-
pletely and the massage function starts
running one minute later. The massage
cycle is approximately 10 minutes and
the break time is 10 seconds between
two cycles.
Note: Three massage cycles in a row
5
are followed by a 15 minute break to
prevent the system from overheating.
Operation
The air tubes in the seatback will oper-
ate according to each mode by turning
control 6 to the desired mode:

: mode 2
Operating in order from bottom air tube.

: mode 1
Operating softly in order from bottom
air tube.

: Random mode 1
Operating softly at random.

: Random mode 2
Operating at random.
Note: if you change mode, the new
mode selected replaces the current
mode.
stopping the function
– Turn control 6 to the Off position.
– When you restart the system after
having stopped it, the air pressure
drops completely before the mas-
sage function can start running.
– With the massage function
stopped, if you wish to use the
lumbar support device wait until
the air pressure has dropped
completely.
– Stop the engine.
Note: If the massage function is run-
ning, you cannot use the support device
at the same time.
For safety reasons, avoid
making any adjustments
when driving. The driver
must always be alert to
sudden events which may occur
when driving.
1.19