Sears Kenmore Gas Range Use & Care Manual page 7

Setting the Clock and
Minute Timer
D D I
O OVEN
PREHEAT
S LOCK
D O
@@@
Note: The oven function will not
work if the time of day clock is not
set.
_t_::_ Set t/_e Cock
When the range is first plugged in, or when the power supply to the range
has been interrupted, the display will flash "12:00".
1. Push _.
2. Within 5 seconds, push and hold the _ or G until the correct
time of day appears in the display.
Note: The clock cannot be changed
during
any timed bake or self-clean _:_
cycle.
"_o Set the _ii :sure T_sqe
1. Push @,
2. Push the _ to increase the time in one minute increments. Push
to increase the time in 10 minute increments.
and hold the The
timer can be set for any amount of time from 1 minute to 11 hours and
59 minutes.
Note: If you push the _ first, the timer will advance to 11 hours
and 59 minutes.
3. The display shows the timer count down in minutes until one minute
remains. Then the display will count down in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then
continue to beep 3 times every 60 seconds until @ is pushed.
Note: The minute timer does not start or stop cooking. It serves as an extra
timer in the kitchen that will beep when the set time has run out. The
minute timer can be used alone or during any of the other oven functions.
When the minute timer is in use with any other mode, the minute timer will
be shown in the display. To view other functions, push the function pad for
that mode.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, push and hold the _]
or _ to increase or decrease the time.
To Cancel the Minute Timer before the set time has run out:
Push @.