Sears Kenmore Gas Range Use & Care Manual page 17

General Cleaning
(continued)
The door is heavy. For
safe, temporary storage, lay the door
flat with the inside of the door facing
down.
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges
A (one on each side.)
3. Close the door to the quarter-open position. Grasp the door firmly on
both sides and lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the cleaning
chart under General Cleaning
Lift door straight off 2 door hinges
Pull up with finger
Left Glide
Push down with finger
Figure 1
Figure 2
To Replace Oven Door:
1.
2.
3.
4.
Be sure the hinge arms are m the quarter-open position. Be careful if _%
pulling the hinges open by hand. The hinges may snap back against the <_,
oven frame and could pinch fingers.
Hold the door at the sides near the top. Insert the hinge arms into slots
at the bottom of the door.
Hinge arms must go into the range slots evenly. The hinge arms should
be inserted into the bottom corners of the door as far as they can go.
If the door is not in line with the oven frame, remove it and repeat the
above steps.
©
To
1.
.
3.
.
Re_s_ove a_sd Rep ace Wa_ _ & _£eady l}kawe_ _ (f e%_ _pe_)
Remove Warmer Drawer:
Turn power off before removing the Warm & Ready
drawer.
Open the drawer to the fully opened position.
Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (see figure 1).
Pull the drawer away from the range.
To Replace Warm & Ready Drawer:
1. Pull the bearing glides to the front of the chassis glide (see figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers "click" (approximately 2").
Pull the drawer open again to seat bearing glides into position. If you
do not hear the levers "click" or the bearing glides do not feel
seated remove the drawer and repeat steps 1 thru 3. This will
minimize possible damage to the bearing glides.
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
17