Sears Kenmore Gas Range Use & Care Manual page 16

General Cleaning
continued)
Unlike the standard gas range, THIS
COOKTOP IS NOT REMOVABLE. Do
not attempt to remove or lift the
cooktop.
Note: The burner cap assembly refers
to all parts of the sealed burner unit
(burner cap, burner pan (some
models), trim ring (some models),
locating tab, burner base and
electrode).
Burner Cap
Locating Tabs
Burner Locatin_
Base
Eiectrod(
Trim Ring (some models)
or Burner Pan (some models)
Use caution when
replacing the burner cap so the
electrode is not damaged. This may
cause a delayed ignition or prevent
the burner from igniting.
Any additions, changes
or conversions required in order for
this appliance to satisfactorily meet
the application needs must be made
by an authorized Sears Service
Center.
The cooktop is designed to make cleaning easier. Because the four burners
are sealed, cleanups are easy when spillovers are cleaned up immediately.
To clean, wipe with a clean, damp cloth and wipe dry.
The contoured well areas, burner cap assembly, trim ring (some models),
burner pan (some models) and burner base should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an
uneven flame. See instructions below.
To Clean the Contoured Well Areas
The contoured well is a recessed area located around each burner unit. If a
spill occurs in one of the four well areas, blot up spill with an absorbent
cloth. Rinse with a clean, damp cloth and wipe dry.
To Remove the Burner Cap Assembly
The burner cap assembly parts differ per model. Your assembly will consist
of one of the following combinations: burner cap and trim ring; burner cap
and burner pan; or burner cap, trim ring and burner pan. Remove in the
following order: (1 st) burner cap, (2nd) trim ring and (3rd) burner pan. Do
not operate the burners without the burner cap assembly in place.
To Clean the Burner Cap, Burner Pan (some models) and Trim Ring
(some models)
Use a soap-filled scouring pad or a mild abrasive cleanser to clean burner
caps, trim rings and burner pans.
To Clean the Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned. Use
a small-gauge wire or needle to clean small slots or holes.Use care to
prevent damage to the electrode. If a cleaning cloth should catch the
electrode, it could break or damage the electrode. If the electrode is
damaged or broken, the surface burner will not light.
For proper flow of gas and ignition of the burner--DO NOT ALLOW SPILLS,
FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTERTHE GAS
OPENING. Gas must flow freely through the small hole in the brass orifice
for the burners to light properly. If the orifice gas opening becomes soiled
or clogged, use a small-gauge wire or needle to clean. ALWAYS keep the
burner cap assembly in place whenever a surface burner is in use.
To Replace the Burner Cap Assembly
Make sure the burner cap assembly is thoroughly dry before placing back
on the burner.
1. Lower burner pan (some models) into place around the burner base.
2. Replace trim ring (some models).
3. Find the locating tabs on the burner cap and place in the locating slots
in the burner base. Make sure each burner cap is properly aligned and
level.
4. Turn the burner on to determine if it will light. If the burner does not
light after cleaning, contact an authorized servicer. Do not service the
sealed burner yourself.
16