Removing The Bezel - Dell PowerEdge 1600SC Systems Istallation And Troubleshooting Manual

Bezel
The front bezel has status and attention indicators. You must remove the bezel to remove the cover.

Removing the Bezel

CAUTION: Before you perform this procedure, see
NOTICE: To remove the bezel, the system must be standing upright.
1. Using the system key, unlock the front bezel (see Figure 5-2).
Figure 5-2. Removing the Bezel
NOTICE: Figure 5-2 shows the system standing upright as the bezel is being removed. However, before you service components inside the system, lay
the system on its right side.
2. Slide the latch to the right and pull the upper edge of the bezel away from the front panel (see Figure 5-2).
3. Pivot the bezel downward until it is at right angles to the front panel.
4. Unsnap the bezel from the metal clips on the front panel.
"Safety First—For You and Your System."