Names Of Lead Wires And Destinations - Eclipse ESN E3 High-Power CD Receiver with CDC/E-COM/DSP Control and Wireless Remote Model: 54420 Owner's Manual

Notes
To prevent unconnected leads from shorting out, insulate
them by wrapping their tips with electrical tape. Similarly,
insulate the ends of connected leads.
If an external amplifier is to be connected to the receiver,
be sure to ground its outside housing to the vehicle body
(a metal part).

Names of lead wires and destinations

No. Name
1 ACC
2 B+
3 Ground
4 Antenna power supply Blue
5 Lamp power supply
6 Control power supply
7 E-LAN terminal
8 & 9 Line-in/out terminals
10 Line-out terminals (Nonfader)
11 Speaker terminals
12 Cellular phone mute
13 Digital out terminal
terminal
14 Eclipse Commander
(refer to Page 71)
Wire color Destination
Red Connect where the power comes on
when the ignition is in the ACC
position.
Yellow Connect where the power is constantly
available, regardless of the ignition
switch's position.
Black Connect where good body grounding
is available.
Connect to the automatic-antenna
control terminal of the vehicle.
Orange/White Connect to where power comes on
when the headlights are turned on.
Blue/White Connect to the control terminal for the
external amplifier, etc.
Connect to the E-LAN terminal of the
CD changer, DSP, etc.
Connect to the RCA input connectors
of an external amplifier,or to the RCA
output connectors of a DSP or EQ.
Connect to the RCA input connectors
of a DSP or EQ, or the RCA connectors
of a woofer amplifier.
Connect them to their respective
speakaers.
Pink Connect the ground output terminal
on a mobile phone.
Connect to digital input terminal of the
Eclipse Commander module.
Connect to the Eclipse Commander.
Mounting instruction
69