Switching Audio Control Modes; Enabling The Loudness Control - Eclipse ESN E3 High-Power CD Receiver with CDC/E-COM/DSP Control and Wireless Remote Model: 54420 Owner's Manual

Basic operation

Switching audio control modes

Various audio control modes may be fine-tuned using this
procedure.
1 . Press the [AUDIO CONTROL] button for less than
2 . Turn the [AUDIO CONTROL] button to the left or
• When Tone Control Cancel feature is on, adjustment of
BASS and TREB will be skipped.
• When an optional DSP/EQ unit is connected, the mode
switches from Volume
adjustment. BASS, TREB, BAL, FADER, may be skipped,
and it depends on the type of DSP/EQ and its situation.

Enabling the loudness control

The loudness control may be turned on to emphasize low
and high frequencies at low volume levels.
Loudness compensates for the apparent weakness of low
and high frequencies at low volume by boosting the bass
and treble levels.
1. Press and hold the [AUDIO CONTROL] button until
• To disable the loudness feature, repeat the above
procedure to display the [LOUD OFF] indication.
24
one second.
Pressing the button repeatedly will allow you to control
adjustments of [BASS] (low frequencies), [TREB] (high
frequencies), [FADER] (front-rear speaker balance),
[BAL] (left-right speaker balance), and [SUB-W]
(subwoofer level).
right
It controls levels and adjust the sound to your
preference.
the [LOUD ON] display appears on the screen.
DSP level adjustment EQ level