Table of Contents
Advertisement
Terminal Setup
Configuring the Terminal for Download
The terminal is prepared for the addition of Twin Client by booting to command mode,
selecting the program loader on the terminal, erasing the
port parameters as described in this section. This simple procedure is described in the
following sections, and requires only a few minutes to complete.
Connecting the Cradle
The terminal download requires a serial connection between the terminal and the PC
through a cradle. In preparation for this download perform the following:
•
Connect the selected serial port on the PC to the cradle with a null modem cable.
•
Verify that the cradle is powered on.
Command Mode Safe Boot
On the portable terminal, power the terminal
sequence shown in the following table.
Terminal Model & Keypad
BHT-7500, 36-key
BHT-103, 18-key
Downloading EX3 Files
The EX3 files can be downloaded using the cradle or from the terminal. The download
requires approximately 2 minutes to complete.
Downloading from the Cradle
Command boot the terminal.
The terminal will boot to System Menu.
From the System Menu cursor down or press 4:
2-8
OFF
Command Mode Boot Sequences
Following Power
Key Sequence
Hold
SF
Press and release
SYSTEM MENU
1: EXECUTE PROGRAM
2: DOWNLOAD
3: UPLOAD
4: SET SYSTEM
5: TEST
6: VERSION
7: FTP
8: RF
Set System
Supported Equipment Manual
EEPROM
, and setting the serial
, then boot the terminal using the key
OFF
and
keys.
1
PW.
and press
Enter.
• March, 2006
Advertisement
Table of Contents
