Replacing The Hard Drive In The Hard Drive Kit - Gateway 450RGH Service Manual

Replacing Gateway 450RGH Components
Replacing the hard drive in the hard
drive kit
Tools you need to complete this task:
Screws removed during this task:
1 chrome 2.5 × 4 mm
(hard drive kit)
To replace the hard drive in the hard drive kit:
1
Disconnect the AC adapter, modem and network cables, then prepare the notebook
by following the instructions in
2
Turn the notebook over so the bottom is facing up.
3
Remove the main battery by following the instructions in
battery" on page
4
If the modular bay contains the secondary battery, remove the secondary battery
by following the instructions in
page 10.
5
Remove the hard drive kit by following the instructions in
kit" on page
22
Phillips #0 screwdriver
"Preparing the notebook" on page
8.
"Replacing the modular bay component" on
19.
www.gateway.com
2 chrome 3 × 3.5 mm
(hard drive)
7.
"Removing the main
"Replacing the hard drive