Replacing The Hard Drive In The Hard Drive Kit - Gateway 450Sx4 Service Manual

Replacing the hard drive in the
hard drive kit
Tools you need to complete this task:
Screws removed during this task:
1 chrome 2.5 × 4 mm
(hard drive kit)
To replace the hard drive in the hard drive kit:
1
Disconnect the AC adapter and modem and network cables and prepare
your notebook by following the instructions in "Preparing your notebook"
on page 6.
2
Disconnect your notebook from the optional port replicator by following
the instructions in "Disconnecting from the port replicator" on page 7.
3
Turn your notebook over so the bottom is facing up.
4
Remove the main and optional secondary batteries by following the
instructions in "Removing the batteries" on page 8.
5
Remove the hard drive kit by following the instructions in "Replacing the
hard drive kit" on page 24.
Phillips #0 screwdriver
2 chrome 3 × 3.5 mm
(hard drive)
www.gateway.com

Replacing the hard drive in the hard drive kit

27