Table of Contents
Advertisement
Keyboard: Dell Latitude V710/V740 Service Manual
NOTICE:
To avoid damage to the connector pins, press the keyboard connector evenly into the
interface connector on the system board, and do not reverse the keyboard connector.
2. Connect the keyboard connector to the interface connector on the system board.
The keyboard connector may have a label on it that shows the correct orientation of the keyboard
connector to the interface connector on the system board.
NOTICE:
Position the keyboard flex cable so that it is not pinched when you replace the
keyboard in the bottom case.
3. Rotate the keyboard back and fit it into the bottom case.
Ensure that all four securing tabs are engaged in their respective slots before trying to completely
seat the keyboard. Fitting the tabs to the slots may be easiest when viewed from above and
slightly behind the front edge of the keyboard. Press down on the left and right
help control tab/slot alignment.
When the keyboard appears to be completely seated, confirm that the front edge of the keyboard
is aligned with the edge of the palm rest before proceeding.
4. Check that the keyboard is correctly installed. The keys should be flush with the left and right
surfaces of the palm rest.
NOTE:
The M2.5 x 4 screws are
silver.
5. Replace the four M2.5 x 4-mm screws at the top of the keyboard.
6. Replace the center control cover.
Ensure that the center control cover is snapped in properly so that it is flush with the keyboard.
7. Replace the two M2.5 x 5-mm screws in the back of the hinges.
Back to Contents Page
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...740/v710%20v740%20SERVICE_MANUAL/keyboard.htm (5 of 6)6/21/2004 2:57:01 AM
keys to
Advertisement
Table of Contents
