Advertisement
TING
Review this chaff
to find do-it-yourself
solutions for minor performance
problems,
I
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect electrical supply before servicing or cleaning
the unit. Failure to do so could result in
electrical shock or personal injury from cleaner suddenly starting.
I
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
I. Unplugged atwalloutlet.
2, Trippedcircuit breaker/blown fuseat
household servicepanel.
3. On-Off Switch not turned ON.
4. Trippedthermostaton suctionmotor,
(Brush and light still
work.)
Cleaner won't run.
Poor job of dirt
pick-up
Cleaner picks up movable
rugs-OR- pushes too hard.
I.
Full or clogged
dirt bag.
2.
Wrong Height Adjustment
Lever Setting.
3.
Worn brush.
4.
Clogged nozzle.
5.
Clogged dusttube.
6. Hole inhose.
7. Broken belt,
8. Hose not inserted fully.
!.
Plug in firmly, push On/Off
Switch to ON.
2.
Reset circuit breaker or replace
fuse.
3.
Push On-Off Switch to ON.
4.
Allow cleaner
to cool down for 20-30 minutes
Check for full bag, clogged
filter, nozzle.
1. Change
bag, (page
12).
2,
Adjust setting, (page 6).
Tripped Belt Protection
System.
Dirty Motor Safety Filter,
3.
Change
brush, (page 20).
4.
Clog removal, (page
18).
5.
Clog removal, (page
18).
6.
Replace hose,
7.
Replace belt, (page
15).
8.
Insert hose fully, (page
7).
Ught won't work.
Brush assembly does
not turn.
Performanceindicator
(optional)is red.
9,
10.
I.
2.
I.
2.
3.
4.
I.
2.
3.
4.
5.
Wrong Height Adjustment
Lever Setting.
Wrong speed.
Burned out light bulb.
Attachment
hose not properly inserted
into base at rear.
Height Adjustment
Lever in Bare Floor Setting.
Tripped Belt Protection
Broken belt.
Tripped Belt Protection
System.
Attachment hose not properly inserted
into base at rear.
Height Adjustment
Lever in Bare Floor Setting.
Wrong Height Adjustment,
1.
Full or clogged
dirt bag,
2.
Dirty Motor Safety Filter.
3.
Clogged
airflow passage.
4.
Certain attachment
tools.
9,
10.
I.
2.
I.
2,
3.
4.
I.
2,
3.
4.
5.
Check for clogs, (page
18).
Clean filter, [page
14).
Adjust to higher setting, (page 6),
Use LO speed, (optional-page
6).
Change
light bulb, (page
19).
Check for proper insertion.
Switch lever to ex Io. medium
or high depending
on
carpet
height, (optional-
page 6.).
Reset Belt Protection
System, (page
10).
Replace
belt, (page
15).
Check for clogs, (page
18). Reset Belt Protection
System, (page
10).
Check for proper insertion,
Switch lever to ex Io or auto, low, medium,
or high,
(optional
- page 6).
Raise setting to higher setting, (page
6).
1. Change
bag, (page
12).
2.
Clean filter, (page
14).
3.
Clear clog from airflow passage,
(page
18).
4.
This is normal. Ught should go off when tool is
removed.
21
Advertisement
