Required Installation Tools Voltmeter Wire Strippers Electric Drill & Bits Phillips Screw Driver Convoluted Tubing * Solder Gun * Wire Crimpers Shrink Tube * Electrical Tape * Optional Important Information 1. Test all circuits with a voltmeter. 2. Make all wiring connections with the supplied solderless crimp connectors.
14 Pin Con nec tor Wire Color De scrip tion Red/White Parking Light Polarity (+) or (-) Select Red/Black Parking Light Output(s) - 2 Wires for European Models Battery (+) Gray Armed (-) Output Pre-wired to Starter Disable Relay Black Battery (-) Violet Siren (-) Output...
Installation Procedures Con trol Unit 1. Select a location under the dash that will allow you to use the tie wraps to securely fasten the control unit. 2. Mount the control unit as high as possible to ensure maximum range. 3.
Valet Switch 1. Discuss placement with the owner. 2. Choose a location for the valet switch that is hidden, but convenient for the owner to access. 3. Drill a ¼" hole and mount the switch. 4. Route the valet switch wires to the control unit. 5.
Park ing Lights 1. If the parking lights are positive trigger, connect the RED/WHITE wire to the battery positive (+) terminal through the 20 amp fuse. NOTE: Do not con nect the RED/WHITE wire to the con trol unit RED wire. 2.
Door Lock/Un lock CAU TION: Be sure to ver ify the type of door lock sys tem you are work ing with. Some types of door lock sys tems re quire op tional re lays, for ex am ple, re verse po lar ity type door locks.
Power and Ground Con nec tions CAU TION: Do not plug in the sys tem fuses un til the fi nal step be low. 1. Connect the alarm RED wire to one of the supplied fuse assemblies. 2. Connect the alarm RED/WHITE wire to the other fuse assembly (if the vehicle parking lights are positive).
Programming Alarm System Features All programmable alarm features are accomplished by turning the ignition key on (or starting the vehicle) and flicking the valet switch on and off a pre-set number of times. 1. Remove the alarm from valet. Programming cannot be accessed while the alarm is in the valet mode indicated by the LED on solid red.
Add ing or De let ing Re mote Con trols The alarm allows the user to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. All re mote con trol pro gram ming fea tures are ac com plished by turn ing the ig ni tion key on (or start ing the ve hi cle) and flicking the valet switch on and off a pre set number of times.