Park Ing Lights; In Te Rior Light Trig Ger/Il Lu Mi Na Tion; Starter Dis Able - Avital AMX7 Installation Manual

Park ing Lights

1. If the parking lights are positive trigger, connect the RED/WHITE wire
to the battery positive (+) terminal through the 20 amp fuse.
NOTE: Do not con nect the RED/WHITE wire to the con trol unit RED wire.
2. If the parking lights are negative (-) trigger, connect the RED/WHITE
wire to control unit BLACK wire.
3. Connect the RED/BLACK wire to the vehicle parking light wire.

In te rior Light Trig ger/Il lu mi na tion

The system's door trigger will accept a positive or negative door trigger
input. When the alarm is remotely disarmed, the interior lights will turn on
for 30 seconds or until the ignition key is turned on. The WHITE/BLACK
interior light supply wire serves two purposes. It informs the alarm whether
the door trigger polarity is positive or negative switching and provides a
positive or negative supply for interior light illumination.
1. Con nect the alarm WHITE wire to the ve hi cle door trig ger wire(s).
2. If the door trigger is negative switching, connect the alarm
WHITE/BLACK wire to ground.
3. If the door trigger wire is positive switching, connect the alarm
WHITE/BLACK wire to a constant fused +12 volt source.

Starter Dis able

Make sure the yellow relay wires are solidly connected. The starter circuit
may draw very high current. We recommend that all connections be
soldered.
1. Locate the ignition switch wireloom under the dashboard.
2. Use a voltmeter to find the one wire that will show +12 volts while the
ignition key is in the "CRANKING" cycle only. This should be the
starter solenoid wire.
3. Cut the starter solenoid wire. Test by trying to crank the starter with the
ignition key. If it will not crank, you have the correct wire.
4. Connect one YELLOW wire to the key side.
5. Connect the other YELLOW wire to the starter side.
Hurricane
8
2
/AMX78 (2) Installation Manual