Interior Light Illumination; Channel 2 Accessory Output (Trunk Release); Channel 6 Accessory Output; Channel 9 Accessory Output - Avital AviStart 6500 Installation Manual

Remote engine starter & vehicle security system

Hide thumbs Also See for AviStart 6500:

Table of Contents

Interior Light Illumination

1. Connect the WHITE wire to the vehicle door trigger wire.

2. If the door trigger is negative, connect the WHITE/BLACK wire to ground.

3. If the door trigger wire is positive switching, connect the WHITE/BLACK

wire to a fused constant +12 volt source. Do note use the alarm RED wire.

The DARK BLUE wire provides a 0.75 second ground output when the

TRUNK button is pressed for 1-2 seconds while the alarm is disarmed only. If

the TRUNK button is continually pressed, the output will stay at ground as

long as the button is held. Most factory trunk releases are positive trigger and

require an optional relay.

The LIGHT BLUE wire provides a 0.75 second ground output when the

ARM/DISARM and SILENT buttons are pressed at the same time for 1-2

seconds. If the ARM/DISARM and SILENT buttons are continually pressed, the

output will stay at ground as long as the buttons are held. This output can be

used for optional accessories such as window roll-up/down or any other

accessory requiring a (-) input.

The BLUE/YELLOW wire provides a 0.75 second output when the SILENT and

START buttons are pressed at the same time for 1-2 seconds. If the SILENT and

START button are continually pressed, the output will stay at ground as long

as the buttons are held. This output can be used for optional accessories such

as a fuel filler door release or any other accessory requiring a (-) input.

The GRAY/BLACK wire will provide a continual ground output for as long as

the vehicle is in the remote start mode. This output can be used for additional

ignition, starter or heater/AC relays, as well as VATS, Passlok and Passkey

bypass.

AviStart 6500 Installation Manual

Table of Contents