Cisco DPC User Manual page 102

Frequently Asked Questions
4 Click the Up/Down selector arrows located to the right of the Connect Via
section of the TCP/IP window, and then click Using DHCP Server.
5 Click Options in the TCP/IP window, and then click Active in the TCP/IP
Options window.
Note: Make sure that the Load only when needed option is unchecked.
6 Verify that the Use 802.3 option located in the upper-right corner of the TCP/IP
window is unchecked. If there is a check mark in the option, uncheck the option,
and then click Info in the lower-left corner.
7 Is there a Hardware Address listed in this window?
If yes, click OK. To close the TCP/IP Control Panel window, click File, and
then scroll down to click Close. You have completed this procedure.
If no, you must power off your Macintosh.
8 With the power off, simultaneously press and hold down the Command
(Apple), Option, P, and R keys on your keyboard. Keeping those keys pressed
down, power on your Macintosh but do not release these keys until you hear the
Apple chime at least three times, then release the keys and let the computer
restart.
9 When your computer fully reboots, repeat steps 1 through 7 to verify that all
TCP/IP settings are correct. If your computer still does not have a Hardware
Address, contact your authorized Apple dealer or Apple technical support center
for further assistance.
Q. What if I don't subscribe to cable TV?
A. If cable TV is available in your area, data service may be made available with or
without subscribing to cable TV service. Contact your local service provider for
complete information on cable services, including high-speed Internet access.
Q. How do I arrange for installation?
A. Call your cable telephony service provider to inquire about professional
installation. A professional installation ensures proper cable connection to the
modem and to your PC, and it ensures the proper configuration of all hardware and
software settings. Contact your cable telephony service provider for more
information about installation.
Q. How does the residential gateway connect to my computer?
A. The residential gateway connects to the 10/100BASE-T Ethernet port on your PC.
If your PC is not equipped with an Ethernet interface, an Ethernet card is available
from your local PC or office supply retailer, or from your service provider.
Q. After my residential gateway is connected, how do I access the Internet?
A. Your local service provider becomes your Internet Service Provider (ISP). They
offer a wide range of services including e-mail, chat, news, and information services.
Your service provider will provide the software you will need.
102 4024320 Rev A