Safety And Tools; Safety Precautions - Fujitsu SPARC ENTERPRISE M4000 Service Manual

1
C H A P T E R

Safety and Tools

This chapter describes safety and tools information. The information is organized
into the following topics:
"Safety Precautions" on page 1-1
■
"System Precautions" on page 1-2
■
"System Precautions" on page 1-2
■
1.1

Safety Precautions

To protect both yourself and the equipment, observe the following safety
precautions.
ESD Precautions
TABLE 1-1
Item Problem
ESD Electrostatic
jack/wrist or Discharge (ESD)
foot strap
ESD mat ESD
ESD ESD
packaging
box
Precaution
Connect the ESD connector to your server and wear the wrist strap or foot
strap when handling printed circuit boards. There are two antistatic strap
attachment points on the chassis:
1. Right side towards the front
2. Left side towards the rear
An approved ESD mat provides protection from static damage when used
with a wrist strap or foot strap. The mat also cushions and protects small
parts that are attached to printed circuit boards.
Place the board or component in the ESD safe packaging box after you
remove it.
1-1