Filter Position; Gain Value - Sony PMW-320K Operating Instructions Manual

• AF (Auto Focus mode)
• MF (Manual Focus mode)
• MF* (Manual Focus mode when the MF Assist
function is on)
• Full MF (Full Manual Focus mode)
c External device control
"REC2" is displayed when MAINTENANCE
>Camera Config >HD-SDI Remote I/F is set to
[Chara] in the setup menu and a recording control
signal is output from the HD/SD SDI OUT
connector.
d Operation status of connected i.LINK
device
The operating format (HDV or DV) and operation
status of that device are indicated as follows.
Indication Meaning
HDV recording in progress
zREC
Standby for HDV recording
STBY
DV recording in progress
zREC
Standby for DV recording
STBY
e Video level indication
An indication is displayed together with an
appropriate ND filter position number when the
light level of the subject is too high or too low.
f Timecode
Caution message
Indicates the elapsed recording/playback time,
timecode, user bits data or other information
selected by the DISPLAY switch (see page 21).
Also indicates a caution message when caution is
required such as when you try to change settings.
g Brightness level
Indicates the average brightness level (%) of the
detection area.
h External input source
Indicates the type of external input signal (HDV)
to be recorded.
i Recording of external input
Indicates "EXT" when an external input is
recorded.
j Electric color temperature filter
Appears when the CC 5600K function is set to on.
k Filter position
Indicates the currently selected ND filter position
number. (see page 16).
When ELECTRICAL CC is assigned to an
assignable switch, the electrical filter position (A/
B/C/D) appears to the right of the ND filter
position (1 to 4), as shown on the previous page.
l White balance memory
Indicates the currently selected white balance
automatic adjustment memory.
ATW: ATW (Auto Tracing White Balance) mode
W:A: Memory A mode
W:B: Memory B mode
W:P: Preset mode
3200: When the assignable switch to which Color
Temp SW 3200K has been assigned is on
4300: When the assignable switch to which Color
Temp SW 4300K has been assigned is on
5600: When the assignable switch to which Color
Temp SW 5600K has been assigned is on
6300: When the assignable switch to which Color
Temp SW 6300K has been assigned is on
m Gain value
Indicates the gain value (in dB) of the video
amplifier, as set by the GAIN selector.
n Shutter
Indicates the shutter speed or the shutter mode.
For details, see "Setting the Electronic Shutter"
(page 54).
o Audio level meters
Indicate the audio levels of channel 1 and channel
2.
p Remaining media capacity
Indicates the recording time remaining for each of
the media loaded in the slots. The available time
for recording with the current video format
(recording bit rate) is calculated according to the
remaining space of each media and indicated in
time units of minutes. A lock icon appears if the
media is write-protected.
q Histogram
Shows a pixel distribution of video luminance
(HD mode only).
Viewfinder Screen Display 31