Sony EVI-H100S Technical Manual page 7

 IMAGE FLIP switch
Flips the image upside down. Normally set this to OFF when
you use the camera. When the camera is attached to the
ceiling, set this to ON. Before you set the IMAGE FLIP
switch, turn off the unit (or set to standby mode) and then,
turn the power on by connecting the power adaptor, by
VISCA control or the remote commander. When you switch
this, the preset setting is returned to the initial setting.
 IR SELECT switch
 VISCA RS-422 connector
 SYSTEM SELECT switch
This switch allows you to select the video format of the
signal to be output from the VIDEO OUT connectors.
Notes
 Be sure to set this switch before you turn on the power of the
camera. You can also set this switch in the standby mode of
the camera. After completing the setting, turn on the power
of the camera by connecting it to an AC outlet using the
supplied AC power adaptor and AC power cord, by using
the VISCA command or remote commander.
 Be sure to use a Phillips-head screwdriver when changing
the switch position. If you use a tool other than the
designated screwdriver, the crossed groove may be damaged.
 This camera does not include a function that automatically
selects video output signals based on the DVI monitor's
resolution. Be sure to configure settings based on the
monitor manually. (EVI-H100V)
 HDTV video signal outputs display without distortion on
monitors with 16:9 aspect ratios.
Set this arrow to the
desired video format.
Switch EVI-H100S
Video format
position
1080i/
0
9.94 (29.97PsF)
1 1080p/29.97
2 720p/9.94
3 720p/29.97
4 NTSC (LB) Yes (SD OUT)
 No output
6 No output
7 VISCA Control
8 1080i/0 (2PsF)
9 720p/0
A 720p/2
B 1080i/0
C PAL (LB) Yes (SD OUT)
D No output
E No output
F No output
Yes: Outputs the image signal.
No: Does not output the image signal
LB: Abbreviation of LETTER BOX. A 4:3 aspect ratio
video signal converted from 16:9 is output with a blank
area (no signal, black) top and bottom to display the
image on a 4:3 aspect ratio monitor without distortion.
Notes
 If the switch position is set to "no output, " the
POWER lamp and STANDBY lamp will both remain
lit. In such cases, control via the remote commander
and VISCA commands is disabled.
 The VISCA CONTROL switch position allows you to
configure the video format via external
communication. Note that your configured video
format will be activated only after restarting the
camera. For details on the video output format
settings command, see page 33.
 SD OUT VIDEO connector
 HD OUT HD-SDI connector (EVI-H100S), VIDEO OUT
connector (EVI-H100V)
PLUG & PLAY
TMDS
Locations of Controls
EVI-H100V
support support
Yes Yes
Yes Yes
9.94 Hz
Yes Yes system
Yes Yes
No
— — —
— — —
Yes Yes —
Yes Yes
Yes Yes
0 Hz
Yes Yes
system
Yes Yes
No
— — —
— — —
— — —
ANALOG
7