D70 Mode; Overview; Switching The Mode - Sony EVI-H100S Technical Manual

Hd color video camera
Hide thumbs Also See for EVI-H100S:
Table of Contents

Advertisement

Overview

The D70 mode allows you to control the EVI-H100S/
H100V using VISCA commands for the EVI-D70/P.
Most of the VISCA commands for the EVI-H100S/
H100V correspond to one for the EVI-D70/P. However,
some of the VISCA commands for the EVI-H100S/
H100V are different from those for the EVI-D70/P in
definitions of parameters.
When you send those commands to an EVI-H100S/
H100V whose D70 mode is set to ON, the camera
translates the parameters for the EVI-D70/P to those
for the EVI-H100S/H100V and executes the command.
The following parameters are subject to translation.
 Zoom position
 Pan-tilt speed
 Pan-tilt position
Notes
 Even if you set the D70 mode to ON, the EVI-
H100S/H100V may not emulate the EVI-D70/P
perfectly. This is caused by differences in hardware
between the two models.
 The functions that are provided with the EVI-D70/
P but not with the EVI-H100S/H100V cannot be
executed.

D70 Mode

Switching the Mode

You can switch the D70 mode ON or OFF by switching
the BOTTOM switch at the bottom of the EVI-H100S/
H100V. To change the D70 mode setting, move the
BOTTOM switch to ON or OFF while the camera's
power is off or the camera is in standby mode. Then,
turn the power on by connecting the camera to an AC
outlet or by using the VISCA commands or the Remote
Commander.
It takes about 7-16 seconds for the image to be
displayed after Pan/Tilt initialization motion has
stopped.
Do not turn off DC power until the image has been
displayed.
The mode will not change if you change the switch
setting of the BOTTOM switch after the power has
been turned on.
After you change the mode, previously saved position
preset data will be lost. (Zoom, Pan/Tilt positions, etc.
will be reset to their initial settings.)
47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Evi-h100v

Table of Contents