Sony EVI-H100S Technical Manual page 15

Note
When in Auto_ICR_OFF state and WB data is added (default), a
malfunction may occur when the subjects largely consisting of blue
and green colors are taken.
Camera ID
The ID can be set up to 65,536 (0000 to FFFF). As this
will be memorized in the nonvolatile memory inside
the camera, data will be saved regardless of whether it
has been backed up.
Effect
It consists of the following functions.
• Neg. Art: Negative/Positive Reversal
• Black White: Monochrome Image
Checking the Location of the Camera for
Signals from the IR Remote Commander
The supplied Remote Commander may not work
correctly near inverter lighting fixtures. Good IR
detection can be verified to determine proper camera
location.
While the camera is being initialized after the power is
turned on by connecting the camera to an AC outlet
using the AC power adaptor and AC power cord, or by
using a VISCA command, the camera detects whether
or not the camera is able to receive infrared signals
from the Remote Commander. You can check the result
of this operation via the IR_ConditionInq command
(see page 37).
When the installation location does not allow stable
reception, try to install the camera farther away from
the inverter lighting fixtures.
Others
Power On/Off
Powers the camera on and off. When the power is off,
the camera is able to accept only the lowest level of
VISCA Commands and POWER of the Remote
Commander; the display and other features are turned
off.
I/F clear
Clears the Command buffer of the camera. Clearing
the buffer can also be carried out from the control
application software when the power is on.
Address set
VISCA is a protocol, which normally can support a
daisy chain of up to seven attached devices. Therefore,
whenever a camera is connected for the first time, be
sure to use the address set to confirm the address.
Memory (Position Preset)
Using the position preset function, 6 sets of camera
shooting conditions can be stored and recalled.
This function allows you to achieve the desired status
instantly without adjusting the following items each
time.
 Pan/Tilt Position
 Zoom Position
 Digital Zoom On/Off
 Focus Auto/Manual
 Focus Position
 AE Mode
 Shutter control parameters
 Bright Control
 Iris control parameters
 Gain control parameters
 Exposure Compensation On/Off
 Exposure Level
 Backlight Compensation On/Off
 Slow Shutter Auto/Manual
 White Balance Mode
 R/B Gain
 Aperture
 ICR Shoot On/Off
 WD On/Off
The settings are recalled when the power is turned on.
For setting items, see the "Initial Settings, Position Preset"
section on page 16.
Note
If the camera is placed on a desk, when you pan the
camera to the right or left beyond 120° with the camera
tilted downward by 20° (or tilted upward by 20° if it is
installed on a ceiling), the camera base may be
captured by the lens, depending on the zoom position
of the lens.
Basic Functions
1