Creating Punch Holes For A Print Job - Kyocera TASKalfa 3051ci User Manual

Finishing

Creating Punch Holes for a Print Job

1
2
3
7-7
device shown in blue in the Device options list, the Punch Unit Settings
dialog box appears. If the device listing is already selected, double-click the
option to open the Punch Unit Settings dialog box.
Punch cannot be used when Booklet is selected in the Layout tab.
Finishing edge should be selected before any other features in the Finishing
tab. If set last, Finishing edge might change any settings that you previously
made under Punch.
The finishing device must support the Punch feature.
Available punch options are set in Device Settings and depend on the punch
unit installed on the device and selected.
In the Finishing tab, click the icons to select Off or to select the number of hole
punches:
2 hole (inches/metric based)
3 hole (inches based)
4 hole (inches/metric based)
Click OK to return to the Print dialog box.
Click OK to start printing.
User Guide