Security > Server Groups > Radius - Dell PowerConnect W-Airwave Configuration Manual

Security > Server Groups > RADIUS
You can configure RADIUS servers for use by a server group. The Security > Server Groups > RADIUS page
displays current RADIUS servers available for inclusion in server groups. Select Add to create a new RADIUS
server, or click the pencil icon next to an existing RADIUS server to edit the configuration.
The Security > Server Groups > Add New RADIUS Server page contains the following fields, as described in
Table 75:
Table 75
Field
General Settings
Folder
Name
Other Settings
Host IP Address
Key (Confirm Key)
Auth Port
Acct Port
Retransmits (0-3)
Timeout
NAS ID
NAS IP
Use MD5
Enable
Source Interface
Select Add to complete the configuration of the RADIUS server, or click Save to complete the editing of an
existing server. The new server appears on the Security > Server Groups > RADIUS page. This server is now
available to be used by server groups.
146 | Configuration Reference
Security > Server Groups > RADIUS
Default
Top
Blank
1812
1813
3
(1-30 sec)
No
Yes
Description
Set the folder with which the server is associated. The drop-down menu displays
all folders available for association with the server group.
Enter the name of the server.
Set the IP address of the authentication server.
Set the shared secret between the controller and the authentication server. The
maximum length is 48 bytes.
Set the authentication port on the server.
Set the accounting port on the server.
Set the Maximum number of retries sent to the server by the controller before the
server is marked as down.
Set the maximum time, in seconds, that the controller waits before timing out the
request and resending it.
Set the Network Access Server (NAS) identifier to use in RADIUS packets.
Set the NAS IP address to send in RADIUS packets.
You can configure a "global" NAS IP address that the controller uses for
communications with all RADIUS servers. If you do not configure a server-specific
NAS IP, the global NAS IP is used.
Enable or disable the use of MD5 hashing for cleartext passwords.
Enable or disable the RADIUS server.
Enter a VLAN number ID between 1-4094.
Allows you to use source IP addresses to differentiate RADIUS requests.
Associates a VLAN interface with the RADIUS server to allow the server-specific
source interface to override the global configuration.
If you associate a Source Interface (by entering a VLAN number) with a configured
server, then the source IP address of the packet will be that interface's IP address.
If you do not associate the Source Interface with a configured server (leave the
field blank), the IP address of the global Source Interface will be used. Requires a
minimum version of 6.1.0.0.
Dell PowerConnect W-AirWave 7.5 | Configuration Guide