Profiles > Mobility Switch > Port Switching; Profiles > Mobility Switch > Vlan - Dell PowerConnect W-Airwave Configuration Manual

3. Select Add or Save. The added or edited profile appears on the Mobility Switch page, and on the details page.
Profiles > Mobility Switch > Port Switching
Port Switching creates a switching profile that can be applied to any interface, interface group, or a port-channel.
Perform these steps to configure a Mobility Switch > Port Switching profile:
1. Select Profiles > Mobility Switch > Port Switching in the Navigation pane. The details page summarizes the
current profiles of this type.
2. Select the Add button to create a new Port Switching profile, or select the pencil icon next to an existing
profile to edit. Complete the settings as described in
Table 47
Field
General Settings
Folder
Name
Other Settings
Access Mode VLAN (1-4094)
Native VLAN Mode (1-4094)
Max Bandwidth Rate Limit
(50-100)
Enable Broadcast Traffic
Rate Limit
Enable Multicast Traffic Rate
Limit
Enable Unicast Rate Limit
Switchport Mode
Trunk Mode Allowed VLANs
3. Select Add or Save. The added or edited profile appears on the Mobility Switch page, and on the details page.
Profiles > Mobility Switch > VLAN
This profile creates a VLAN with the specified configuration parameters. To enable role-based access for wired
clients connected to an untrusted VLAN and/or port on the switch, you must specify the wired AAA profile you
100 | Configuration Reference
Profiles > Mobility Switch > Port Switching Profile Settings
Default
Top
Blank
1
1
50
Yes
No
Yes
access
1-4094
Table 47:
Description
Set the folder with which the profile is associated. The drop-down menu displays
all folders available for association with the profile.
Enter the name of the profile.
Specify the VLAN ID for the port, when the switch-port mode is access.
Specify the VLAN for incoming untagged packets, when the switch-port mode is
trunk.
When a packet goes out of a trunk interface in native VLAN, it will be untagged. By
default, VLAN 1 is the native VLAN. The native VLAN should be part of the trunk
allowed VLANs.
Specify the storm control bandwidth.
Enables storm control for broadcast.
Enables storm control for multicast.
Enables storm control for unicast.
Specify whether the port is an access port connected to an end device or a trunk
port for uplink connectivity.
access—Configures the port to be an access port.

trunk—Configures the port to be a trunk port.

NOTE: Trunk mode and UnTrusted Port mode cannot be configured simultaneously.
Identifies the VLAN IDs for which the trunk carries the traffic. Enter a list or range
of vlan tags and pools (e.g. 'pool1,pool2,1,5,20-40'), or 'all' or 'none.'
NOTE: Trunk mode and UnTrusted Port mode cannot be configured simultaneously.
Dell PowerConnect W-AirWave 7.5 | Configuration Guide