Dell 3100cn Color Laser Printer User Manual page 36

Purpose:
To configure the IPX/SPX settings.
The change becomes effective after the printer is turned off and then on again.
Values:
Automatically sets the frame type.
Auto*
Uses the Ethernet frame type.
Ethernet II
Uses the IEEE802.3 frame type.
Ethernet 802.3
Uses the IEEE802.3/IEEE802.2 frame type.
Ethernet 802.2
Use the IEEE802.3/IEEE802.2/SNAP frame type.
Ethernet SNAP
NOTE: The IPX/SPX menu is only displayed when an optional multi protocol card is installed on the printer.
IP Filter
Purpose:
To specify the reception of data from certain IP addresses for blocking. You can set up to five IP addresses.
The change becomes effective after the printer is turned off and then on again.
Values:
Sets the IP address for Filter n.
Filter n Address
(n is 1 to 5.)
Sets the mask for Filter n.
Mask
Disable the IP Filter feature for Filter n.
Mode Off*
Accepts an access from specified IP address.
Accept
Rejects an access from specified IP address.
Reject
Init NVRAM
Purpose:
To initialize network data stored in NVRAM.
Adobe Protocol
Purpose: