Values:
Disables the use of refilled toner cartridges.
Off*
Enables the use of refilled toner cartridges.
On
Parallel
The Parallel menu can be adjusted to configure the parallel interface.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
ECP
Purpose:
To specify the ECP communication mode of the parallel interface.
The change becomes effective after the printer is turned off and then on again.
Values:
The ECP communication mode is enabled.
On*
The ECP communication mode is disabled.
Off
Adobe Protocol
Purpose:
To specify PostScript communication protocol for the parallel interface.
The change becomes effective after the printer is turned off and then on again.
Values:
Used when auto-detecting the PostScript communication protocol.
Auto
Used when no special processing is required for data.
RAW
Used when the communication protocol is in ASCII format.
Standard
Used when the communication protocol is in binary format.
BCP
Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code.
TBCP*
Reports