Dell 3100cn Color Laser Printer User Manual page 180

IP Address AutoIP
Mode
DHCP
BOOTP
RARP
Manually
Set
IP Address
Subnet Mask
Gateway Address
DNS DNS Mode
DNS Server ADDR
1 WINS Mode
WINS*
WINS Primary Server
WINS Secondary Server Sets a back up WINS server address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value
LPD Connection Time-Out
IP Filter
Port9100 Port Number
Connection Time-Out
IP Filter
1
Printer URI
IPP*
Connection Time-Out
Port Number
Maximum Sessions
HTTP Port Number
Simultaneous
Connections
Connection Time-Out
FTP Password
Connection Time-Out
*1 An optional multi protocol card is required to use.
NetWare
Purpose:
To configure detailed settings for IPX/SPX and NetWare.
Values:
IPX/SPX Frame Auto
Type
Ethernet II
Ethernet 802.3
Ethernet 802.2
Ethernet SNAP
Current Frame Type
Automatically sets the IP address.
Uses DHCP to set the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Enables the IP address set in IP Address.
Sets the IP address allocated to the printer in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a
value between 0 and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
Sets the subnet mask in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0 and
255. Note that 255.255.255.255 is invalid.
Sets the gateway address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0
and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
Select the check box to get the DNS server address automatically from the DHCP server.
Sets the DNS server address.
Select the check box to get the WINS server address automatically from the DHCP server.
Sets WINS server address in the nnn.nnn.nnn.nnn format. Each section of nnn.nnn.nnn.nnn is a value between 0
and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
between 0 and 254. Note that values 127 and 224 to 254 are not valid for the first three-digits.
Sets the connection timeout period from 1 to 1000 seconds.
To set the IP Filter settings, click IP Filter. The
Sets the port number from 9000 to 9999.
Sets the connection timeout period between 1 and 1000 seconds.
To set the IP Filter settings, click IP Filter. The
Displays the printer URI.
Sets the connection timeout period from 1 to 1000 seconds.
Displays the port number for receiving requests from the client.
Displays the maximum number of connections received simultaneously by the client.
Sets the port number to 80 and 9000 to 9999.
Displays the maximum number of connections received simultaneously by the client.
Sets the connection timeout period from 1 to 255 seconds.
Sets whether to enable or disable the password. And also specifies the password value up to seven characters.
Sets the connection timeout period from 1 to 1000 seconds.
Specifies the active frame type automatically.
Selects Ethernet II frame type.
Selects IEEE802.3 frame type.
Selects IEEE802.2 frame type.
Selects SNAP frame type.
Displays the current frame type.
"IP Filter" page is displayed.
"IP Filter" page is displayed.