Brother DCP 8040 - B/W Laser - All-in-One Service Manual page 137

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
(10) Remove the two pan (washer) M2.6x6 Taptite screws.
(11) Remove the heat roller 25.
(12) Remove the halogen lamp.
Screw, pan
(washer) M2.6x6
FU frame upper
NOTE:
When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater
lamp is correct referring to the figure above.
!
CAUTION:
Never touch the surface of the halogen heater lamp.
When securing the screw to assemble the halogen lamp connector plate, ensure you use
the Fu lamp assembly jig ASSY as shown in the figure below to avoid damaging the edge of
the halogen heater lamp.
Heat roller 25
Halogen lamp connector plate
Halogen heater lamp
Heat roller 25
Halogen lamp
Fig. 4-100
Fig. 4-101
4-56
Halogen lamp
Screw, pan (washer) M2.6x6
Fu lamp assembly jig ASSY
Screw, pan (washer)
M2.6x6
Colored side
115V:Orange
230V:Black
Halogen lamp
connector plate