Shutdown And Startup Problems - Fujitsu LifeBook C1410 User Manual

clio.book Page 54 Friday, June 2, 2006 10:37 AM
L i f e B o o k C 1 4 0 0 S e r i e s N o t e b o o k - S e c t i o n F i v e
Problem
Your notebook will not No batteries are installed.
work on battery alone.
The batteries are improperly
(continued) installed.
Your installed batteries
are faulty.
The batteries seem to You are running an application
discharge too quickly. that uses a lot of power due to
frequent hard drive access or
DVD/CD-ROM access, use of
a modem or LAN PC card.
The power savings features
may be disabled.
The brightness is turned all
the way up.
The batteries are very old.
The batteries have been
exposed to high temperatures.
The batteries are too hot
or too cold.

Shutdown and Startup Problems

The Suspend/Resume Suspend/Resume button is
button does not work. disabled from the Power ->
Advanced submenu of the
setup utility.
You did not hold the button
in long enough.
There may be a conflict with
the application software.
The system powers up, and The boot sequence settings
displays power on informa- of the setup utility are not
tion, but fails to load the compatible with your
operating system. configuration.
You have a secured system
requiring a password to load
your operating system.
Internal hard drive was
not detected.
54
Possible Cause
Install a charged battery.
Verify that the batteries are properly connected
by re-installing them.
Verify the condition of the batteries using the
Status Indicator panel and replace or remove
any batteries that are shorted. (See Status Indicator
Panel on page 11 for more information)
Use both the primary battery and an optional
second battery and/or use a power adapter for this
application when at all possible.
Check the power management and/or setup utility
settings in the Power Savings menu and adjust
according to your operating needs.
Turn down the brightness adjustment. The higher
the brightness the more power your display uses.
Replace the batteries.
Replace the batteries.
Restore the notebook to normal operating tempera-
ture. Charging icon on the Status Indicator panel
will flash when battery is outside of operating range.
Enable the button from the setup utility.
Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
Close all applications and try the button again.
Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu. (See BIOS Setup
Utility on page 27 for more information)
Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly. (See BIOS Setup Utility
on page 27 for more information)
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
Possible Solutions