Memory Problems; Modem Problems; Parallel, Serial And Usb Device Problems; Pc Card Problems - Fujitsu LifeBook C1410 User Manual

clio.book Page 52 Friday, June 2, 2006 10:37 AM
L i f e B o o k C 1 4 0 0 S e r i e s N o t e b o o k - S e c t i o n F i v e
Problem

Memory Problems

Your Power On screen, or Your memory upgrade module
Main menu of the BIOS is not properly installed.
setup utility information,
does not show the correct
You have a memory failure.
amount of installed
memory.

Modem Problems

Messages about modem Modem operation messages
operation. are generated by whichever
modem application is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel The device is not properly
port device, a serial port installed.
device or a USB device.
The device may have been
Your LifeBook notebook
installed while an application
does not recognize the
was running, so your notebook
device, or the device does
is not aware of its installation.
not seem to work properly.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for the device.
Your device and another device
are assigned the same I/O
address.
Parallel port is set to output
only.

PC Card Problems

A card inserted in the PC The card is not properly
Card slot does not work or inserted.
is locking up the system.
The card may have been
inserted while an application
was running, so your notebook
is not aware of its insertion.
Your software may not have
the correct software driver
active.
You may have the wrong I/O
address selected for your PC
Card device.
Your PC Card device and
another device are assigned the
same I/O address.
52
Possible Cause
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 42
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 57 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 44 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 27 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-insert the card. (See PC Cards/
ExpressCards™ on page 40 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 27 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Possible Solutions