Port Replicator Problems; Floppy Disk Drive Problems; Hard Drive Problems; Keyboard Or Mouse Problems - Fujitsu LifeBook C1410 User Manual

clio.book Page 51 Friday, June 2, 2006 10:37 AM
Problem
The Optical Drive Access The auto insertion function is
indicator on the Status active and is checking to see if
Indicator Panel blinks at a disc is ready to run.
regular intervals when no
disc is in the tray or the
optical drive is not installed.

Port Replicator Problems

Note: Be sure to power down your LifeBook notebook before adding a printer to the Port Replicator parallel port.
LifeBook notebook does Port Replicator AC adapter is
not turn on when installed not plugged in.
in the optional Port
Notebook is not properly
Replicator
seated in the Port Replicator.

Floppy Disk Drive Problems

You cannot access your You tried to write to a write
floppy disk. protected floppy disk.
Floppy disk is not loaded
correctly.
The floppy disk drive may not
be properly installed.
Security is set to protect access
to floppy disk data.

Hard Drive Problems

You cannot access your The wrong drive designator
hard drive. was used by an application
when a bootable CD-ROM was
used to start the notebook.
Security is set in the BIOS so
your operating system cannot
be started without a password.

Keyboard or Mouse Problems

The built-in keyboard does The notebook has gone into
not seem to work. Suspend mode.
Your application has locked
out your keyboard.
You have installed an Your external device is not
external keyboard or properly installed.
mouse, and it does not
Your operating system soft-
seem to work.
ware is not set up with correct
software driver for that device.
You have connected an Your operating system soft-
external keyboard or a ware is not setup with correct
mouse and it seems to be software driver for that device.
locking up the system.
Your system has crashed.
Possible Cause
This is normal. However, you may disable this
feature.
Provide power to the Port Replicator.
Remove and re-dock your LifeBook notebook.
Eject the floppy disk and set it to write enable.
(See Preparing a Disk for Use on page 38 for more
information)
Eject floppy disk, check orientation and re-insert.
(See Ejecting a Disk on page 38 for more information)
Remove and re-install your floppy disk drive.
Verify your password and security settings.
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
Push the Power/Suspend/Resume button.
Try to use your integrated pointing device to restart
your system.
Re-install your device. (See Device Ports on page 44
for more information)
Check your device and operating system
documentation and activate the proper driver.
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
T r o u b l e s h o o t i n g
Possible Solutions
51