Time Settings - TP-Link TL-WA7210N User Manual

TL-WA7210N
SNMP Agent - Choose Enable to open this function if you want to have remote control through
SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
SysContact - The textual identification of the contact person for this managed node.
SysName - An administratively-assigned name for this managed node.
SysLocation - The physical location of this node.

Note:
Specifying one of these values via the Device's Web-Based Utility makes the corresponding
object read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent
was restarted.
Get Community - Enter the community name that allows Read-Only access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is public.
Get Source - Get source defines the IP address or subnet for management systems that can read
information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is private.
Set Source - Set source defines the IP address or subnet for management systems that can
control this 'set' community device.

Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
Click the Save button to save your settings.

4.9.2 Time Settings

Choose menu "System Tools > Time Settings", and then you can configure the time on the
following screen.
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
Figure 4-22
58