Table of Contents
Advertisement
Camera Mounting
Caution
• Do not drive the screws into a soft material. Drive the screws into a secure area of the wall,
such as a column, otherwise the camera may fall and be damaged.
• Make sure you attach the safety wire when mounting the camera, to prevent the camera from
falling.
• Do not place the camera near any heat emitting devices (e.g., water heaters, air
conditioners). (Placing the camera near heat emitting devices can cause the built-in sensor
to not detect properly.)
Note
• Use a LAN cable that is no more than 30 m (98 feet 5 inches) long to connect the
camera and the power transfer unit.
• Use screws that are appropriate for the material of the wall.
• The included screws are for use with wooden walls only.
• Prolonged exposure to direct sunlight or halogen light may damage the camera's image
sensor. Mount the camera appropriately.
• Make sure to waterproof any openings or holes made during installation.
• When connecting the cable, waterproof the cable using the included right-angle joint, foam
strip and self bonding tape.
• When installing cables through the ground, do not connect cables under the ground. Install
cables through a conduit to protect them from water.
• Refer to page 9-12 for information about the operation of the built-in sensor before deciding
where to install the camera.
1
Secure the safety wire to the camera using screw B (included) and
washer S (included).
• Make sure you attach the safety wire when mounting the camera, to prevent the camera
from falling.
2
Remove the tab on the flexible stand, then pass an outdoor LAN cable
through the notch.
18
Safety wire
Washer S
Screw B
Hide quick links:
Advertisement
Table of Contents
