Table of Contents
Advertisement
Installation
Precautions
• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough,
then the camera may fall and hurt someone.
• The following steps of installation and connection work should be done by qualified service personnel or
system installers and should conform to all local codes.
• Be sure to turn the power off before installation and connection.
• Do not install the camera near the air outlet of an air conditioner.
■ Mounting the Camera
Ceiling mount
The figure shows an example of the camera mounted
on a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for
filling gaps and holes with waterproof material.
■ Construction
40 1-1/2B 30 mm
{1-3/16 inches} MAX
PT11 crest (taper pipe thread) 300 mm{11-13/16 inches}
40 1-1/2A deep 30 mm
{1-3/16 inches} MAX
PT11 crest (parallel pipe thread)
STEP 1
Attach the camera to the housing base, and secure the
camera and the housing base with the mounting
screws (x3).
The screws that are removed need to be used during
reassembly. Be careful to not lose them.
* Special screw (mounting screw)
Use a hexagon wrench for the hexagon screw (M5).
16
(60 mm
{2-3/8
inches})
85 mm
{3-11/32 inches}
Fixing screws (3 pcs.)
Housing base
Camera
Protection Cover
Note:
• When removing the front and rear sun shields,
perform steps 5 to 7 in the reverse order.
Protection Cover
Important:
• Remove the Protection Cover from the dome
cover after the installation is complete.
Hide quick links:
Advertisement
Table of Contents
