Maintenance And Care - Bissell Total Floors® Wet & Dry Hard Floor Cleaner 2949 User Manual

M
aintenance and care
Emptying The Collection Tank
Remove the collection tank lid. then dump the
dirty water and debris into the sink, toilet, laun-
dry tub or outside. Rinse the tank out with warm
water and replace it in the unit.
Checking The Filter
While the collection tank is out of the unit,
remove the Pleated filter from the top of the tank.
Remove dirt and debris from the pleats by gently
tapping the filter over the wastebasket or outside.
the Pleated filter can also be rinsed under water
to clean.
NOTE: If the Pleated Filter is rinsed
with warm water to clean, it is
recommended to leave it out of
the unit to air dry before placing it
back in the unit.
Visit www.bissell.com for replacement parts.
Cleaning The Gentle
Clean™ Brush or Pad
Gentle Clean™Brush
Remove the brush from the unit and rinse
under warm water.
Gentle Clean™Pad
Remove the gentle clean™ Pad Plate from
the unit. Peel the pad from the Pad Plate and
toss in the wash!
Removing Wet Clean Nozzle
Remove the Wet clean nozzle by pulling tab on
right and left side of nozzle. Rinse any dirt and
grime off the nozzle under warm tap water.
to replace the Wet clean nozzle, insert the 4
tabs along the bottom of the nozzle Window
and gently snap the Wet cleaning nozzle back
into place.
Storing Your Hard Floor Cleaner
your Powerease/total floors Wet & dry Hard
floor cleaner can be stored Ready-to-use,
by leaving water and formula in the unit.
be sure to remove wet gentle clean™
Pad before storing.
8
w w w . b i s s e l l . c o m
Tip:
While using the Powerease /
total floors Wet & dry Hard
floor cleaner in the Wet
cleaning mode, make sure
to listen for the change in the
sound to alert you when the
collection tank is full.
Tip:
if there are large pieces of
debris in the water, you may
not want to empty the tank
into your sink.
WARNING:
to reduce the risk of fire,
electric shock or injury unplug
from outlet before servicing.
Tip:
if the Pleated filter is rinsed
with warm water to clean, it
is recommended to leave it out
of the unit to air dry before
placing it back in the unit.
8 0 0 . 2 3 7 . 7 6 9 1