Read Circuit; Frequency Characteristic Of Programmable Filter - Fujitsu MPB3021AT Product Manual

Disk drives
Hide thumbs Also See for MPB3021AT:
Table of Contents

Advertisement

4.6.3

Read circuit

The head read signal from the PreAMP is regulated by the automatic gain control (AGC)
circuit. Then the output is converted into the sampled read data pulse by the programmable
filter circuit and the adaptive equalizer circuit. This clock signal is converted into the NRZ
data by the 8/9 GCR decoder circuit based on the read data maximum-likelihood-detected by
the Viterbi detection circuit, then is sent to the HDC.
(1)
AGC circuit
The AGC circuit automatically regulates the output amplitude to a constant value even when
the input amplitude level fluctuates. The AGC amplifier output is maintained at a constant
level even when the head output fluctuates due to the head characteristics or outer/inner head
positions.
(2)
Programmable filter
The programmable filter circuit has a low-pass filter function that eliminates unnecessary high
frequency noise component and a high frequency boost-up function that equalizes the
waveform of the read signal.
Cut-off frequency of the low-pass filter and boost-up gain are controlled from each DAC
circuit in read channel by an instruction of the serial data signal from MPU (M1). The MPU
optimizes the cut-off frequency and boost-up gain according to the transfer frequency of each
zone.
Figure 4.5 shows the frequency characteristic sample of the programmable filter.
Figure 4.5
(3)
Adaptive equalizer circuit
This circuit is 3-tap sampled analog transversal filter circuit that cosine-equalizes the head read
signal to the partial response class 4 (PR4) waveform.
4 - 12

Frequency characteristic of programmable filter

C141-E045-02EN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mpb3032atMpb3043atMpb3052atMpb3054atMpb3064at

Table of Contents